Just finished the config file saving and loading, so now when exiting the host software will save the current state of the software.
The next time you run it, it will restore everything the way it was!
Recent Posts
Recent Comments
Archives
Categories
- Jon Watson Macro
- Model CS 1 , Rapid Prototype Shaper /Printer
- PCB's and schematics
- Rapid shot
- UV cured modeling
- UV links
- Uncategorized
- cnc, guides – screws
- deposition,extrusion,sintering
- electronics
- firmware
- general UV curing chemistry
- hardware links
- host software
- projectors
- projectors/optics
- resin
- tips and techniques
- vat & stage
9:22 pm, May 29, 2011Eric Wilson /
Hi, Can you drop me a line? I cannot find your email on your site. Or even a “contact me” page. Thx, Eric ericdwilson [AT] yahoo [DOT] com